Can You Powder Coat A Bike Frame
Most epoxies burn at these temperatures but standard jb weld does just fine up to 500 f. Picked up a decent pete matthews frame last week stripped it ready for shot blasting and powder coating when i noticed a couple of small dents.
I knew it could be done to bike frames but the ones i had seen looked unimpressive and they were expensive.
Can you powder coat a bike frame. In short no it will not. And if you strip the paint off. This means the engine seat tank wiring harness and even every nut and bolt needs to be removed from the frame.
This has to be done since the frame will be going in to a large oven that would otherwise ruin other parts. Be careful to make sure that any rubber or plastic is removed as these will not withstand the stripping and powder coating process. The difficulty with this part is the choice of the adhesive given that the powder coater will cure the frame at above 400 degrees f.
Eqc are experts in bicycle frame refurbishment for both high volume and low volume contracts prior to delivering your frames remove wheels fittings bearings etc. Maldon shot blasting powder coating ltd carry out work on pushbike frames to a very high and long lasting standard. Putting a powder coating on a carbon fiber bike is just plain wrong.
Once formed the logos need to be bonded to the frame. It produces a strong smooth and durable coating. It looks amazing and it cost less than 200.
If you are having a tandem bicycle frame powder coated you need to check that the oven is large enough. You can find many more colors and flamboyant finishers available in liquid. A metallic glittery coating is possible.
Powder coating push bike frames. In the past when i ve taken frames to a mate in my local nissan dealer i ve filled any dents with resin hardener etc and its been no problem. Remember our motto do it once do it right.
This past winter one of my riding buddies got his santa cruz nomad powder coated at pristine powder coating here in denver. Our work will last you for many years to come as powder coating is extremely chip resistant over stove or wet paints. Save yourself the extra money and just stick with a good liquid paint applied under proper conditions by an expert.
Powder coating doesn t use solvents or leave liquid overspray and so it is relatively environmentally friendly and clean. I had always pictured powder coating as something done to jeep bumpers and wrought iron fences. Media blasting carbon fiber is also very risky unless a plastic media is used.
When a motorcycle frame is powder coated it needs to be completely stripped down to the frame. Old bikes rarely increase in value unless you have some sort of classic vintage bike with some sort or racing history or uniqueness to it.